The program terminated with the instruction HLT.
MOV instruction is used to copy values from source to destination. For a programmer it is much easier to have some value be kept in a variable named var1' then at the'. therefore the transfer of result from 0600H to 0700H is accomplished in two stages by using successive MOV instructions, for an instance,įirstly, the content of 0600H is DX register and then the content of DX register is moved to 0700H. MOV BX, CX copy contents of CX to memory at B800:015E. mov cx,1 sub cx,1 CX 0, ZF 1 mov ax,0FFFFh inc ax AX 0, ZF 1. We have chosen DX (we could have selected register AX also, because once DS is initialized to 2000H the contents of register AX are no longer useful for this purpose. memory address is encoded within the instruction, or a register holds the.
Cx programmer memory mov instruction registration#
So the result of addition which is present at 0600H should be moved to any one registration amongst the general purpose registers, except BX and CX, or else the contents of BX and CX will be changed. Data Transfer instruction MOV, Moves data from register to register, register to memory, memory to register, memory to accumulator, accumulator to memory, etc. In particular case of the 8086/8088 instruction set, there is no instruction for direct transfer of data from the memory source operand to the memory destination operand rather than the string instructions. The result will be goes in destination operand 0600H. The immediate data byte 05H is added to content of 0600H by using the ADD instruction. Due to these reasons, the first option is preferable. Thus the second option will need execution time and more memory. In the first option the opcode is just of 2 bytes, whereas the second option will have 4 bytes of opcode. (b) MOV CX, Move directly from 0500H to CX (a) MOV CX, BX As the contents of BX register will be similar as 0500H after execution
For this data transfer, there can be 2 options as shown. The similar data is moved also to the CX register. The flow chart for the program is shown in given figure.Īfter initializing the data segment register the content of the location 0500H are moved to the BX register by using MOV instruction. Consider that the data is located in the segment specified by the data segment register which contain 2000H. Store up the result of the addition in 0700H.
Add immediate byte 05H to the data residing in memory location, whose address is computed by using DS=2000H and offset=0600H. Example : Write a program to move the contents of the memory location 0500H to BX and also to register CX.
0 kommentar(er)
